Modular hospital buildings
With the Pacarada Modular Building System, hospitals can be extended or built new. Wards, patient rooms and functional areas are made in a factory in Germany and assembled alongside a working hospital. Construction time on the hospital grounds stays short.

What the system does for your hospital
- Short time on the hospital grounds: Most of the work happens in the factory. That shortens the time patients and staff are affected by building work.
- Patient rooms with bathroom as modules: Rooms and bathrooms arrive finished from the factory, in consistent quality.
- Services prepared: The electrical installation is a plug-in system as in the automotive industry and is prepared in the factory.
- Adaptable: If needs change, areas can be extended, converted or dismantled.
Typical projects
Wards and patient rooms, extensions to existing hospitals, medical centres and outpatient clinics, administration and staff buildings, and replacement buildings during a refurbishment.
Which areas suit modular construction
| Area | Method | Note |
|---|---|---|
| Wards and patient rooms | room modules (3D) with finished bathroom | high repetition, short assembly |
| Examination, treatment, outpatient clinics, medical centres | room modules or wall and floor elements (2D) | grid follows the room schedule |
| Administration, on-call rooms, staff accommodation | room modules (3D) | as in office and residential buildings |
| Operating theatres, intensive care, radiology | columns and beams (1D) with wall and floor elements | large spans, high loads, dense services: coordinate early with the specialist designers |
| Interim buildings during a refurbishment | room modules (3D) | can be dismantled and reused elsewhere |
Requirements a hospital building must meet
In Germany a hospital is a special building. In addition to the state building code, state-specific rules for hospital construction apply, together with standards and recommendations that specialist designers bring into the design:
- Hygiene: surfaces, room layout and circulation following the recommendations of KRINKO at the Robert Koch Institute.
- Ventilation: DIN 1946-4 for buildings and rooms in healthcare.
- Fire protection: fire compartments and escape routes that also work for bed-bound patients. A fire protection concept is mandatory.
- Accessibility: DIN 18040, plus door and corridor widths for beds.
- Organisation: DIN 13080 structures the functional areas and units of a hospital.
- Services and loads: medical gases, emergency power, heavy equipment and low-vibration floors.
These requirements apply whatever the construction method. The advantage of modular construction is that they are implemented in the factory under constant conditions and checked before delivery. More on this in the guide article Fire protection and sound insulation in steel modular construction.
Building next to a working hospital
Most hospital projects are extensions and replacement buildings on a site that operates around the clock. Noise, dust, vibration and site traffic disturb patients and operations. In modular construction the building is made in the factory while only foundations and connections are prepared on the grounds. Assembly itself is short. If crane position and deliveries are planned early, emergency access stays clear at all times.
German hospital reform: sites are changing
Under the German hospital reform, services are being concentrated at fewer sites, while other hospitals are being converted into outpatient or cross-sector care facilities. The transformation fund provides up to 50 billion euros for this from 2026 to 2035. For many operators this means extending, converting and repurposing buildings in a short time. A building system that is bolted and plugged can later be changed, extended or dismantled again.
How a hospital project runs
- Clarify needs and the room schedule with the operator and users.
- Check feasibility: plot, connection to the existing building, crane position and access.
- Design with the architect and the structural, fire, hygiene and building services designers, matched to the grid of the system.
- Permit and production: while foundations and connections are built on the grounds, the components are made in the factory.
- Assembly, connection to the existing building and commissioning.
The system behind it: made in Germany
Every building is based on the same system. Columns and beams, wall and floor elements and finished room modules are bolted and plugged together at the internationally patented Cube. The Pacarada Modular Building System is engineered and manufactured in Germany. It is open to clients, architects, municipalities and contractors who want to build with it. You will find all data on the Facts and figures page.
Frequently asked questions
Can building take place while the hospital stays in operation?
Yes. The modules arrive finished and are assembled in a short time. That limits noise and site traffic.
Do different rules apply to a modular hospital?
No. The same requirements apply as for any hospital. Specialist designers define them, and they are implemented in the factory.
Are large functional areas possible?
Yes. Large rooms are built with columns and beams and with wall and floor elements, smaller rooms as finished room modules.
Can a modular building move to another site later?
Yes. In the Pacarada system the components are bolted and plugged. A building can be dismantled and rebuilt elsewhere, for example an interim building once a refurbishment is finished.
Which areas of a hospital suit modular construction?
Especially areas with many identical rooms: wards, patient rooms with bathroom, examination and treatment rooms, administration and staff accommodation. Areas with large spans and a lot of services, such as operating theatres and radiology, are built with columns, beams and wall and floor elements.
More building types
- Schools
- Nurseries
- Retirement and care homes
- Healthcare buildings with the Pacarada system
- Guide: Building permits for modular buildings in Germany and type approval
- All 18 building types at a glance
Planning a project? Send us your enquiry, ideally with drawings. We will tell you whether and how your project can be built with the Pacarada Modular Building System.
One system for your next project
The internationally patented Pacarada modular building system is developed and manufactured in Germany. Whether you are a developer, a local authority, an architect or a contractor, we work out with you which combination of 1D, 2D and 3D components suits your site, your schedule and your budget.